Chapter 8: System Hardware Overview
5495975-1EN Rev.9 8-74
© 2013-2017 General Electric Company. All rights reserved.
Installation
Compression Band
1. The compression band can be attached on the standard table top by putting the pulleys inside the
slots on the table top aluminum frame on both front and rear sides (Figure 8-55).
2. The compression band can be removed from the standard table top by sliding the pulleys out of the
table top aluminum frame on both front and rear sides.
Figure 8-55 Compression Band installation
Hand Grips
1. Mount the hand grip on the standard table top aluminum frame with putting the pulley inside the
slot.
2. Located the hand grip to the desired position and turn the lock knob clockwise to fix it at the desired
position (Figure 8-56).
3. To remove the hand grip from the table, release the lock knob by turning it counterclockwise. Then it
can be slided out of from the slot of the table top frame.
To Next Page
Loading...
