Chapter 8: System Hardware Overview
5495975-1EN Rev.9 8-47
© 2013-2017 General Electric Company. All rights reserved.
Vertical Adjust Handle
1. Grasp the handle and depress the inner switch (Figure 8-34).
2. Move the arm up or down.
3. Release the switch when the desired height is reached.
Figure 8-34 Vertical adjust handle
Insert or Remove Grids
Refer to Grids(p. 8-68) for more information about available grids and grid accessories.
You have the choice of acquiring images with or without the grid. Grid exams require inserting the proper
grid. Grids are stored in the wall mounted accessories holder.
CAUTION Grid handling: Handle grids with care and place in accessories holder when not in
use. Dropping the grid could cause damage and reduced image quality.
To remove the grid, use the handle to pull the grid out of the wallstand or accessories holder. To insert it,
slide the grid through the groove at the lateral side of the wallstand until it rests completely in the slot. An
interlock within the receptor senses the new grid.
To Next Page
Loading...
