Chapter 11: Image Viewer
5495975-1EN Rev.9 11-12
© 2013-2017 General Electric Company. All rights reserved.
Customize System Annotations
Follow this process to customize the system annotations that appear on the image.
1. Select the Image Tools panel – Annotation tab if necessary.
2. Click [CUSTOM].
The Annotation screen (Figure 11-7) appears.
Figure 11-7 Custom Annotation selections
3. Select (check) the annotations you want to appear.
4. Adjust the Font Size, if necessary.
The available font sizes are:
–-2 (smallest)
–-1
Manual
Shutter
Manually adjusts the image shutter.
Collimation is detected using image-based processing. In some
cases, the FOV detected by the system does not match the actual
exposed FOV. Use the Manual Shutter tool to correct this.
Note: This function is only available when the image is open in a
live exam or for re-processed images.
Refer to Adjust Image Shutter (Crop Image)
(p. 11-15) for more
information.
Table 11-4 Annotations/Mask tool descriptions
Tool Description
To Next Page
Loading...
