Appendix A: Login Administration
5495975-1EN Rev.9 A-9
© 2013-2017 General Electric Company. All rights reserved.
Figure A-9 Remove From a Group
Change User Roles
Users roles cannot be directly changed from the Local Users panel. Roles are actually associated with
groups, and users belong to groups. In order to change the roles for a user, you must change the roles of
a group to which that user belongs.
Locking / Unlocking a User
Once a user is in context, you can see if the user is locked by looking at the status of the Locked check
box in the bottom panel. If this is checked, then the user cannot login even with a correct password.
1. To unlock the user, uncheck the checkbox, and press Apply Configuration button.
2. To lock a user, check the checkbox and press the Apply Configuration button.
Note: If Emergency User is enabled, you can still login through Emergency User while the system is lock.
Force a User to Change Password on Next Login
Often times if you are an administrator, you would like to force a user to change his or her password the
next time they login for security reasons. You can do this using EA3.
1. Select User
2. Check the Change Password on Next Login checkbox in the bottom panel.
If this is checked, then the user will be asked to change their password on the next successful login.
Note: Once the user changes the password on the next login the check will be removed from this user.
To Next Page
Loading...
