Appendix A: Login Administration
5495975-1EN Rev.9 A-11
© 2013-2017 General Electric Company. All rights reserved.
Figure A-10 Groups window
Add a Local Group
2. Press [Add Local Group]
When this button is pressed a popup panel is displayed.
3. Enter the new group's name (which must be unique).
If any errors are encountered, you will receive an error message box. If you receive the error message
box, changes were not saved to the database, and you can correct your errors and try again. Possible
errors that can be encountered when adding a group are:
– Group name already exists in the database
– Application session timeout
Once a local group is added, it is automatically highlighted in the Local Groups list box on the
lefthand site, and it is highlighted. Once a group is highlighted, all information and buttons in the cen-
ter panel (i.e. Group Name, Remove Group Button, Roles checkboxes, Apply Roles button, Group Mem-
bers list box, Add Membership button, and Remove Membership button) refer to that group.
To Next Page
Loading...
