Chapter 15: Preferences
5495975-1EN Rev.9 15-28
© 2013-2017 General Electric Company. All rights reserved.
Configure Pre-set Annotations
Viewer Preferences allow you to add, edit, or remove pre-set annotations.
Follow this process to configure pre-set annotations.
1. From the Worklist screen, click [UTILITIES].
2. Select Preferences > Viewer.
3. Click Pre-set Annotation [EDIT].
The Pre-set Annotations editing screen (Figure 15-26) appears.
Figure 15-26 Pre-set Annotation editing
4. Adjust the speed of brightness and contrast.
There are 5 grades in the speed of brightness and contrast (Figure 15-27).
Figure 15-27 Brightness and Contrast Adjustment Speed
The selected grades will influence the speed of brightness and contrast in Viewer screen
(Figure 15-28).
To Next Page
Loading...
