GE Optima XR646 - Delete Suspended Procedures; Add or Edit Patient Information; Overview

Chapter 9: Worklist
5495975-1EN Rev.9 9-13
© 2013-2017 General Electric Company. All rights reserved.
Delete Suspended Procedures
Suspended procedures cannot be deleted unless their status is changed to “Completed” or “Discontin-
ued”
1. Select the suspended procedure to delete.
 A message appears: “The patient entry you are trying to delete is still in progress. Would you like to
mark the patient as ‘Completed’ / ‘Discontinued’ and proceed with deletion?”
2. Click [COMPLETE] or [DISCONTINUE].
 [COMPLETE] changes the Status to of the procedures to “Completed.” If enabled, any acquired
images are auto pushed, auto printed, and sent to PACS.
 [DISCONTINUE] changes the Status to “Discontinued.” Any acquired images are marked as Discon-
tinued and the information is sent to PACS.
 [CANCEL] closes the message and returns you to the Worklist without deleting procedures.
 The procedures are removed from the Worklist.
Add or Edit Patient Information
Overview
The Add Patient (Figure 9-10) and Patient Information screens allow you to enter patient and procedure
information before starting an exam or to view the information at any time.
Note: This screen may also be known as the Medical Procedure Card or MPC.
 To add a patient to the Worklist, click [ADD PATIENT] and enter or select the appropriate information.
Note: Make sure the patient’s name, ID number, birth date, and gender information are entered cor-
rectly.
CAUTION Use only standard alphanumeric characters to complete the screen.
 To view the patient information from the Worklist or Image Management screens, select the exam
then click [PATIENT INFORMATION]. Patient information is not editable when launched from the Image
Management screen.
 To view the patient information from the Acquisition or Image Viewer screens, click [PATIENT INFOR-
MATION]. Patient information is not editable when launched from these screens.
Patient Information provided by the HIS/RIS cannot be edited.
Patient Information entered locally is editable until the exam is started. It is not editable after the exam is
started or in progress.
Note: The Patient Information button is unavailable when multiple exams are selected at the same
time.