Chapter 15: Preferences
5495975-1EN Rev.9 15-49
© 2013-2017 General Electric Company. All rights reserved.
Image Processing
The Image Processing preferences allow you to change which look is the default for the anatomical view.
Image Processing Preferences also allow you to view the settings of default factory looks or to create up
to five (5) custom looks.
Note: Custom looks and the default looks mapping can be backed up by having GE Service personnel
perform a system backup. It is recommended that a system backup be performed after any
change to the default looks mapping or when custom looks are built. Ask your GE Service person-
nel to perform the system backup at their next visit. GE Service personnel can restore the settings
from the backup, if necessary.
Figure 15-39 Preferences – Image Processing
Change Default Factory Looks for Exams
The Default Factory Looks screen (Figure 15-40) allows you to change the default processing setting for
all 34 representative anatomical views, and then map this change to related anatomical views. Note that
this may over-ride existing default settings.
At the initial applications setup, the radiologist chooses the default look for each anatomical view. Appli-
cation specialists assign the looks to the system.
To Next Page
Loading...
