Chapter 9: Worklist
5495975-1EN Rev.9 9-11
© 2013-2017 General Electric Company. All rights reserved.
Select Procedures
Use the following processes to select a patient from the Worklist. This process assumes the patient
already exists on the system. If the patient is not on the Worklist, you must add the patient first. Refer to
Overview
(p. 9-1) for more information.
Select a Single Procedure
1. Close or suspend any open exams, if necessary. Refer to Chapter 10: Image Acquisition-End Exam
(p. 10-31) for more information.
The Worklist screen appears.
2. Select the procedure from the Worklist.
3. Refer to Chapter 10: Image Acquisition
to conduct the exam.
Select Multiple Procedures
You may select multiple procedures for the same patient to begin image acquisition.
Note: The Patient Name, Patient ID #, and Exam Date must match exactly in order to be selected.
1. Sort the Worklist by Patient Name, if necessary.
2. Click on all the procedures that are to be selected.
3. Click on [START EXAM]
4. Select matching protocol from list in drop down menu.
Figure 9-8 Selecting Protocol From Drop Down Menu
5. Continue to select protocols to match the protocol in the drop down list.
6. Click on [ACCEPT] when all exams have had a protocol assigned.
To Next Page
Loading...
