Chapter 15: Preferences
5495975-1EN Rev.9 15-19
© 2013-2017 General Electric Company. All rights reserved.
Auto Refresh
The Worklist Auto-Refresh feature automatically refreshes the Patient Worklist at predefined time inter-
vals.
Note: You will not be able to make selections or access Worklist functions while the Worklist is refresh-
ing.
Note: For large facilities, it is recommended that the auto refresh interval be set to a short time, for
example, every 1 or 2 minutes. The system will refresh more often, but each refresh will take less
time to complete.
Preset Names
The Preset Names screen (Figure 15-20) allows you to add, remove, or edit the names that appear on the
Add Patient/Patient Information screen’s Operators, Performing Physicians, and Referring Physicians
drop-down lists (Figure 15-19). Operator names must be created if RRA is enabled. Refer to Chapter 13:
Advanced Applications-Repeat/Reject Analysis (RRA) (p. 13-8) for more information.
Figure 15-19 Drop-down lists on the Add Patient screen
Follow the procedures below to Add, Edit, or Remove Preset Names.
1. When finished, click [SAVE] to retain the changes.
Refresh every __
Minutes
If Auto Refresh is [ON], sets how often (in minutes) the Worklist refreshes. The
interval may be between 1 and 9999 minutes.
Table 15-6 Worklist Default Query description
Function Description
To Next Page
Loading...
