GEDA
®
300 Z / ZP
Page 30 of 101 Rev.: 001
BL 121 EN Translation of the original operating manual 2011 / 05
4.10 Other relevant documents
In addition to this manual, the following documents must be observed by
the corresponding target group:
The manuals for the landing-level safety gates / the electric mod-
ules.
Customer service information, if applicable.
Instruction manuals issued by the suppliers of purchased parts
These documents must be supplemented by the operating company with
the national regulations of the country of use applicable in each case. If
the machine is sold or passed on, the documentation must be passed on
as well.
4.11 Export licence
Parts of the machine / electrical control unit may require export licences
depending on the current status of foreign trade law. The customer shall
take responsibility for acquiring the relevant export licence and shall only
proceed in accordance with this licence.
4.12 Warranty
This manual does not contain any warranty agreements. These can be
found in the General Terms and Conditions of Business. Proper use is
a precondition for the warranty.
4.13 GEDA training sessions
GEDA conducts detailed training sessions in order to enable the highest
degree of safety and economic efficiency when operating the machine.
When the machine is delivered, the operating company and its personnel
will receive extensive instruction in function, operation, maintenance, ser-
vicing and troubleshooting. The operating company is recommended to
take advantage of these training sessions. Please contact the GEDA
GmbH customer service department for information on training.
To Next Page
Loading...
