GEDA
®
300 Z / ZP
Page 37 of 101 Rev.: 001
BL 121 EN Translation of the original operating manual 2011 / 05
7.3 Set-up and connection / installation
Precautionary measures stipulated by the company for avoiding
fires, explosions, dust, gas, steam and smoke (during welding,
burning and grinding work) must be observed.
The stated torques must be adhered to. Use a calibrated torque
wrench for this.
Appropriate lifting gear must be used when working with heavy
parts.
Adhere to the minimum requirements for thoroughfares, paths and
emergency exits.
Provide sufficient space to open doors and covers.
Welding, burning and grinding work on the machine must only be
carried out following consultation with and approval from GEDA.
Observe the reduced load-bearing capacity of the car during as-
sembly.
Observe the mast tie distances and trailing cable guide distances.
Observe the load-bearing capacity of the boom truck.
Avoid mixing up / incorrect re-assembly of dismantled parts. Label
parts.
In the event of wind speeds > (45 km/h), bring the car down to the
ground and cease operation.
During installation, never do the following from inside the car:
o reach or lean into the travel path during ascent / descent
o allow parts to project into the travel path during ascent / de-
scent
o stand on the load
o exit the car to climb onto the mast or the building.
Cordon off / mark the assembly / hazard area.
No one is allowed to stand under the assembly / hazard area.
To Next Page
Loading...
