GEDA
®
300 Z / ZP
Page 50 of 101 Rev.: 001
BL 121 EN Translation of the original operating manual 2011 / 05
9.7 Drop-test control unit
(For use exclusively by authorised personnel).
The droptest control serves the sole purpose of performing
a drop test or to travel upwards if the car has travelled too
far down.
1 = EMERGENCY STOP button
2 = UP or “neutral” run button
3 = Spring-return button (release brake)
lways plug the dummy plug (4) of the droptest control in
again once the drop test has been finished. The unit can-
not be operated without the dummy plug.
1
2
3
4
To Next Page
Loading...
