GEDA 300Z - Assembly

GEDA
®
300 Z / ZP
Page 67 of 101 Rev.: 001
BL 121 EN Translation of the original operating manual 2011 / 05
15 Assembly
Safety instructions for assembly / transport
 Precautionary measures stipulated by the company for avoiding
fires, explosions, dust, gas, steam and smoke (during welding,
burning and grinding work) must be observed.
 The stated torques must be adhered to. Use a calibrated torque
wrench for this.
 Appropriate lifting gear must be used when working with heavy
parts.
 Adhere to the minimum requirements for thoroughfares, paths and
emergency exits.
 Provide sufficient space to open doors and covers.
 Only carry out welding, burning and grinding work on the machine
after consultation and approval from GEDA.
 Observe the reduced load-bearing capacity of the car during as-
sembly.
 Observe the mast tie distances and trailing cable guide distances.
 Observe the load-bearing capacity of the boom truck.
 Avoid mixing up / incorrect re-assembly of dismantled parts. Label
parts.
 In the event of wind speeds > (45 km/h), bring the car down to the
ground and cease operation.
WARNING
Danger to life
Raised load.
Do not stand under suspended loads.
Do not stand on suspended loads.
Only lift loads at the suspension points.
Only use suitable lifting gear.