GEDA
®
300 Z / ZP
Page 40 of 101 Rev.: 001
BL 121 EN Translation of the original operating manual 2011 / 05
7.6 Transporting material
The operator is responsible for correct loading and unloading and
for correctly securing the load.
Use appropriate lifting gear for loading and unloading. Only use lift-
ing gear that is designed for the weight of the load.
Never drive the lifting gear into the car.
Secure load with fastenings so that any movement is impossible
during transport.
Distribute the load evenly and centrally in the car.
Observe the maximum permissible load-bearing capacity.
Store the load at a safety distance of min. (50 cm) from any of mov-
ing parts.
Never cover doors, control panels, emergency call system, first aid
kits or warning notices with the load. They must remain accessible
at all times.
Safety rails to prevent people from falling must be provided at load-
ing points ≥ 2.0 m in height.
Persons may only enter the car after the load has been secured.
Material must not project into the travel path of the machine.
When transporting material, this must not lead to a concentration of
abrasive / corrosive substances. If this cannot be excluded with cer-
tainty, then the corrosion protection and / or the functional reliability
of the electrical components must be inspected at regular intervals
and if necessary replaced.
The generation / accumulation of (explosive) fine particulate matter
must be prevented / removed immediately.
When transporting parts that are longer than the platform
(e.g. scaffolding tubes, poles, etc), the support frame must be used.
To Next Page
Loading...
