GEDA
®
300 Z / ZP
Page 36 of 101 Rev.: 001
BL 121 EN Translation of the original operating manual 2011 / 05
Observe the load-bearing capacity of the machine, pedestals, lad-
ders and steps.
Look out for steps and objects on the ground when entering / exit-
ing the car.
A fall-protection device must be worn when working at heights
> (2.0 m).
The machine must not be used as steps or a climbing aid. Only use
tested and stable steps / climbing aids. Keep steps / climbing aids
free of dirt and soiling.
At the end of work or if work is interrupted, the machine must be
turned off at the master switch and secured against unauthorised
switch-on (e.g. with a padlock).
If there is a risk of parts falling into the car, the GEDA protective
roof must be used.
7.2 Transporting the machine / disposing of the machine
When transporting by lorry, the load must be secured according to
international transport guidelines. Avoid overloading the lorry. Pack
parts in such a way to prevent damages.
No-one is allowed to remain standing in the area under or on the
raised machine / parts of the machine.
Only lift the machine using the necessary parts and at the pre-
scribed suspension points.
Only use appropriate and tested transport and load bearing de-
vices. Avoid overloading the transport device / load-handling de-
vice.
Avoid tipping or dropping the machine / forklift at all costs.
The machine must only be transported / set up on foundations with
a sufficient load-bearing capacity.
Ensure that there is a stable equilibrium when transporting with
forklift trucks. Use appropriate means to secure the machine
against slipping / falling. Transport only at walking speed.
Secure the load accordingly when transporting over steep inclines /
slopes.
Label dismantled parts to prevent any mix-up when reassembling.
To Next Page
Loading...
