GEDA
®
300 Z / ZP
Page 35 of 101 Rev.: 001
BL 121 EN Translation of the original operating manual 2011 / 05
7 Obligatory safety instructions
7.1 Basic conduct when working with the machine
The machine must be used with an awareness of hazards, in
a technically fault-free condition and according to the instructions in
this manual.
Acquaint yourself with the way the machine works, the operating
controls and the safety equipment.
The stipulated operating steps and the sequence of steps must be
adhered to.
If there is any lack of clarity regarding proper condition or correct
operation, these points must be clarified. Operation is prohibited un-
til the matter is clarified.
The operator is responsible for third parties in the working area of
the machine.
Unauthorised persons must be kept away from the machine; if nec-
essary set up warning notices.
All safety regulations relevant to the respective job / activity must be
adhered to.
Responsibilities for different activities must be clearly identified and
adhered to. Lack of clarity greatly compromises safety.
Safety and emergency equipment may neither be removed, altered
nor made ineffective and must be inspected at regular intervals to
ensure function and completeness.
Rectify any faults which fall within your area of responsibility.
If faults occur outside your area of responsibility, inform your supe-
rior immediately.
In the event of wind speeds > (72 km / h), bring the car down to the
ground and cease operation.
Smoking, eating, drinking and naked flames are prohibited.
Wear personal protective equipment.
During all types of work, and if conditions are wet, frosty and / or
dirty, keep all floors, steps, pedestals, platforms, and climbing aids
fall-proof and slip-resistant using appropriate measures (e.g. dry,
clean, de-ice).
Remove ice, snow or other contamination.
Do not use in storms (lightnings)
Storing parts / combustible materials in the hazard area / in close
proximity to the machine is prohibited.
To Next Page
Loading...
