GEDA 300Z - 18.7.4 Check safety gear for damage; 18.7.5 Safety gear replacement

GEDA
®
300 Z / ZP
Page 93 of 101 Rev.: 001
BL 121 EN Translation of the original operating manual 2011 / 05
18.7.4 Check safety gear for damage
If any damage is identified on the safety gear, the safety gear must be re-
placed immediately. Machine operation is prohibited until it is repaired.
18.7.5 Safety gear replacement
GEDA safety gear must be replaced with new GEDA safety gear (safety
gear exchange units) after 5 years at the latest.
The obligation to replace safety gear applies to both material hoists and
personnel hoists.
WARNING
Risk of injury
The safety gear must be inspected every 5 years by the manu-
facturer. Repairs must only be carried out by the manufacturer.
 Turn the master switch to the OFF position.
 Secure against being switched on.
 Loosen nut (1).
 Remove protective cover (2).
 Test brake pads for damage.
 Test flyweights for ease of movement.
 Condition of welded seams.
 Condition of springs.
 Corrosion / deformation.
 Put back protective cover.
 Mount protective cover (2) in such a way that
switch tag (3) engages in the slot on the protec-
tive cover. (Alternatively, turn the protective cov-
er anti-clockwise until the switch tag (3) engages
in the slot on the protective cover.)
 Tighten nut (1).
1
3
2