3-57
CHAPTER 3 Settings and Measurement
Setting Selections available
Misc. [DC, RH] Perform Auto Zero
ADJ.
Press right key to execute.
Reset Auto Zero ADJ.
Press right key to execute.
[RMS] RMS value operation
cross value
Set numeric value.
Reads the current
voltage meas. value
Press right key to execute.
Cross value reset
Press right key to execute.
[RH] Burnout check
Press right key to execute.
<Logic/Pulse settings>
Setting Selections available
Logic/Pulse Off, Logic, Pulse
[Logic]
Filter Off, On
Misc. Annotation
text string
Enter text. (Max. 31 characters)
Set
waveform
color
0 to 31 for each of red, green, blue (RGB)
Trace Off, On
[Pulse] Input Off, Revolution counts, Counts, Inst.
Filter Off, On
Slope H, L
EU Function Off, On
Meas. Value Set numeric value.
EU value Set numeric value.
Select Cur, Length, Area, Volume, Velocity, Accel, Freq, Mass, Energy,
Pressure, Flow, Temp, Strain, Brightness, Concentration; Optional
Unit The selections vary depending on the unit selected in the above.
(Enter arbitrary text: Up to 8 characters)
Arbitrary
unit
Enter text.
Misc. Annotation
text string
Enter text. (Max. 31 characters)
Span
Set-
tings
Set numeric value.
Lower
limit
Set numeric value.
Set
waveform
color
0 to 31 for each of red, green, blue (RGB)
Line
Thickness
Setting
1 to 8 dots
Trace Off, On
Pulses per
revolution
1 to 10000
To Next Page
Loading...
