3 -115
CHAPTER 3 Settings and Measurement
(6)-8 FUNC key settings
Set the behavior when the function key is pressed.
[FUNC] key can be set according to each screen mode (Y-T/logging/XY) and operating status (free running/
capturing/replaying) respectively.
By pressing the [FUNC] key, the setting contents are executed immediately.
The contents that can be set in each status are listed below. The " " mark in the table indicates that setting
is possible.
Setting items Free Run Recording Replaying
X-T NAVI × ×
Screen copy
Alarm clear
Pulse operation clear
Internal RAM clear × ×
Next search × ×
Prev. search × ×
Cursor synchronization × ×
Auto save cancel (only when saving automatically) ×
Immediately back up (only when backup is set to On) × ×
Logger NAVI × No status
Screen copy No status
Alarm clear No status
Pulse operation clear No status
Internal RAM clear × No status
Statistical operation clear × No status
Auto save cancel (only when saving automatically) × No status
Immediately back up (only when backup is set to On) × No status
XY NAVI × ×
Screen copy
Alarm clear
Internal RAM clear × ×
XY display clear × ×
Auto save cancel (only when saving automatically) ×
Immediately back up (only when backup is set to On) × ×
To Next Page
Loading...
