GRAPHTEC GL980 - XY Replay; Move to Selected Position; Cursor Synchronization

3-131
CHAPTER 3 Settings and Measurement
Setting Description
Span Set the Span.
You can set it when the analog CH in the Span mode is set to
the axis.
Run All Data XY Execute XY display for all data.
* When the amount of data is large, it may take time to draw
XY graph.
Run Cursors XY The data of the section sandwiched between cursors AB is
XY-displayed.
* When the amount of data is large, it may take time to draw
the XY graph.
XY replay
Setting Description
Set XY Display Perform settings for XY display.
CH Set X-axis and Y-axis of XY graph.
CH1 to CH8
Trace Set the trace of XY graph.
Off, On
Waveforms are not displayed on the screen when trace is set
to Off. They are also not displayed on the digital display.
Position Set the XY position.
0 to 100%
Vernier Set the XY Vernier.
40 to 100%
* The range varies depending on the range setting.
Span Set the Span.
You can set it when the analog CH in the Span mode is set
on the axis.
Reect XY display settings The XY graph with the contents of XY display settings is
redrawn.
* When the amount of data is large, it may take time to draw.
XY Overwrite Set the XY overwrite.
Select File Select the image le to be overwritten and execute
overwriting.
Overwrite clear The XY overwrite is cleared and completed.
Return to Y-T waveform screen The data being replayed is changed to Y-T display.
(8)-1 Move to selected position
Set the position (relative time with the trigger point set as 0) or the time and then move the current selected
cursor (A or B) to the position.
< Position > < Time >
(8)-2 Cursor synchronization
Set function that move two cursors in synchronization.
Setting Description
Off Cursors are not synchronized. Only the specied one cursor moves.
On Two cursors move in synchronization.
* Cursor Synch is turned Off when you move a cursor using the Move to Selected Position or perform Data Search.