GRAPHTEC GL980 - Cursor (Alarm Clear); File

3-24
CHAPTER 3 Settings and Measurement
(12) CURSOR (ALARM CLEAR)
• This key is used to switch between cursor A and B during replay.
Pressing this key switches between cursor A and B.
For details on cursor operation, refer to “3.5 Setting Menus” - “(8) Data replay
menu”.
Cursor B Cursor A
Cursor A Cursor B
• When the alarm setting is “Hold generated Alarm”, the alarm on hold is
cleared.
Alarm-generated channels
Alarm output terminal status
• Black : Alarm is not issued
• Red : Alarm is issued
(13) FILE
This key is used to execute le-related operations.
• Performs the operations (copy, delete, and transfer, etc.) for the internal
memory, SD card and USB memory.
• Execute the screen copy
• Saves all data or data between cursor A and cursor B during replay (set during
replay only)
• Saves the data in the internal RAM to a le.
• Saves or reads the current set conditions. (can be set during Free Running
only).
• Replaces the SD card or USB memory during data capture (Can be set when
data is being backed up.).
For details on the le operation, refer to “3.5 Setting Menus” - “(7) FILE menu”.