GRAPHTEC GL980 - How to Attach the Tilt Stand

2-4
CHAPTER 2 Checks and Preparation
2.4 How to attach the tilt stand
When tilt foot is used When tilt foot is not used
(1) Please pay attention to the mounting position and install the tilt foot.
•
Without Rubber Protector
When tilt foot is used When tilt foot is not used
Fasten with a screw from the
lower hole.
Fasten with a screw from the
upper hole.
Tilt stand
M4 x5
•
With Rubber Protector
Use M4x8 screw and spacer supplied with this device.
When tilt foot is used When tilt foot is not used
Fasten with a screw from the
lower hole.
Fasten with a screw from the
upper hole.
Tilt stand
M4 x 8
Spacer
•
To prevent possible malfunction, do not block the air vents of this device.
•
If you use this device in other position than described in the above, the measurement accuracy may not
meet the specications.
•
To prevent possible falling, attach both tilt stand and tilt foot for this device.