GRAPHTEC GL980 - Installing USB Memory; How to Install USB Memory; USB Memory Specifications

2-17
CHAPTER 2 Checks and Preparation
2.10 Installing USB Memory
•
When handling USB memory, please pay attention to static electricity.
•
Do not remove the USB memory while it is being accessed (Device access indicator turns red and POWER
LED blinks). The captured data may get damaged.
•
When using HDD and USB memory (4GB or more), please format them using FAT32.
How to install USB memory
Install the USB memory in the USB memory slot.
USB memory
When the USB memory is installed in this device, please handle with care.
<USB memory specications>
• Power supply: +5V
• Consumption current: 250 mA or less
• Capacity: No limit (however, up to 4GByte for 1 le)
* USB memory with security function such as ngerprint authentication or USB memory without shell (metal
part) on the connector part cannot be used.
* USB bus power type HDD cannot be used. Format the HDD to FAT32.
For the latest information and support information, please check the following URL.
http://www.graphtec.co.jp