GRAPHTEC GL980 - Start Side Source Setting; Stop Side Source Setting

3-96
CHAPTER 3 Settings and Measurement
(4)-1 Start side source setting
This is used to specify trigger conditions to start data capture.
Selection item Description
Off Starts capturing data unconditionally when you press the [START/STOP] key.
Level Starts capturing data when a specied level is reached.
-> When Level is selected, the condition for each channel must be set.
Refer to “Trigger Level Settings/Alarm Level Settings” desdcribed below.
Alarm Starts capturing data when an alarm is generated in the specied alarm port.
External Input Starts capturing data when an input signal is received from an external trigger terminal.
* A trigger is established at a transition from 5 V (open) to 0 V (shorted to the ground).
A falling edge operation occurs.
Date Refer to "Specied time setting" described below.
Weekly Starts capturing data at the specied time on days of week for which On is set.
Example: On is set for Mon, Tue, Wed, Thu, and Fri, Off is set for Sun and Sat, and 9:00 is
set as the time.
Starts capturing data at 9:00 on weekdays. Does not start capturing data on Sat
and Sun.
Duration Starts capturing data when a specied length of time elapses.
(4)-2 Stop side source setting
This is used to specify trigger conditions to stop data capture.
Selection item Description
Off Stops capturing data unconditionally when you press the [START/STOP] key.
Level Stops capturing data when a specied level is reached.
-> When Level is selected, the condition for each channel must be set.
Refer to “Trigger Level Settings/Alarm Level Settings” desdcribed below.
Alarm Stops capturing data when an alarm is generated in the specied alarm port.
External Input Stops capturing data when an input signal is received from an external trigger terminal.
* A trigger is established at a transition from 5 V (open) to 0 V (shorted to the ground).
A falling edge operation occurs.
Date Refer to "Specied time setting" described below.
Weekly Stops capturing data at the specied time on days of week for which On is set.
Example: On is set for Mon, Tue, Wed, Thu, and Fri, Off is set for Sun and Sat, and 9:00 is
set as the time.
The data is captured at 9:00 on weekdays. Does not stop capturing data on Sat
and Sun..
Duration Stops capturing data when a specied length of time elapses.
When External Input is used as the trigger source, no stop trigger is accepted for 50 ms after capture is
started.