GRAPHTEC GL980 - 3.5 Setting Menus

3-56
CHAPTER 3 Settings and Measurement
3.5 Setting Menus
When you press the [MENU] key during Free Running, the following menu screens appear.
I/F OTHERTRIGDISPAMP DATA
(1) AMP settings
This menu is used to specify input signal-related settings.
< Analog settings >
Setting Selections available
Input Off, DC, RMS, TEMP, RH
Range [Voltage] 20, 50, 100, 200, 500mV; 1, 2, 5, 10, 20, 50, 100, 200, 500V; 1-5V
[RMS] 10, 25, 50, 100, 250, 500mVrms
1, 2.5, 5, 10, 25, 50, 100, 250Vrms
[Temperature] TC-K, TC-J, TC-T, TC-R, TC-E, TC-B, TC-S, TC-N, TC-W
[Humidity] 100% xed
Filter Line, 5, 50, 500Hz, 5k, 50kHz
EU
(Scaling settings)
Function Off, On
Dec pt None, 1 digit, 2 digits, 3 digits, 4 digits after the decimal point
Meas.
Value
Upper limit Set numeric value.
Lower limit Set numeric value.
EU value Upper limit Set numeric value.
Lower limit Set numeric value.
Select Cur, Length, Area, Volume, Velocity, Accel, Freq, Mass, Energy,
Pressure, Flow, Temp, Strain, Brightness, Concentration; Optional
Unit The selections vary depending on the unit selected in the above.
(Enter arbitrary text: Up to 8 characters)
Misc. Annotation text string Enter text. (Max. 31 characters)
Inter-
CH Op
Settings
Function Off, On
Operation Left-hand
side
CH number
Operator +, - , ×, /
Righthand
side
CH number
Scaling /1000000, /1000, ×1, ×1000, ×1000000
Operations
span
Dec pt ×1, ×10, ×100, ×1000, ×10000
Upper limit Set numeric value.
Lower limit Set numeric value.
Select Cur, Length, Area, Volume, Velocity, Accel, Freq, Mass, Energy,
Pressure, Flow, Temp, Strain, Brightness, Concentration; Optional
Unit The selections vary depending on the unit selected in the above.
(Enter arbitrary text: Up to 8 characters)
Span
settings
Upper limit Set numeric value.
Lower limit Set numeric value.
Set waveform color 0 to 31 for each of red, green, blue (RGB)
Line Thickness Setting 1 to 8 dots
Trace Off, On