3-88
CHAPTER 3 Settings and Measurement
(3)-3 XY display
Setting Description
Display mode Set the display mode of the screen.
Y-T, Y-T (full screen), Logging, XY
CH Set the X- axis and Y- axis of XY graph.
CH1 to CH8
Trace Set the trace of XY graph.
Off, On
Waveforms are not displayed on the screen when trace is Off. Also they are not displayed on
the digital display.
Position Set the XY position.
0% to 100%
Vernier Set the XY vernier.
40 to 100%
* The range depends on the range setting.
Span Upper limit Set the span.
You can set it when the analog CH in the Span mode is set on the axis.
Lower limit
Zero point Automatic zero adjustment of the analog CH set to the X-axis and Y-axis is performed.
Origin Set the origin position in the Y graph.
Center, Lower left
Execute Initialize the XY position to the set origin.
Clear waveform at the start of
recording.
Set the enable or disable of XY waveform clearing at the start of capturing.
Off, On
XY display clear Perform the XY waveform clear manually.
XY Overwrite Select File Select the image le to be overwritten and then perform the overwriting.
Overwrite clear The XY overwrite is cleared and completed.
CH (X-axis/Y-axis CH setting)
Set X-axis and Y-axis of XY graph.
You can select from among analog CHs.
Trace
Set the trace of XY waveform.
XY-CH which trace is set to Off is not displayed on the graph and the digital display.
To Next Page
Loading...
