GRAPHTEC GL980 - Interface Settings

3-105
CHAPTER 3 Settings and Measurement
(5) Interface settings
This menu is used to specify conditions for PC connection.
Setting Selection available
End-of-line character Set the end-of-line character for sending and
receiving the control commands.
CR + LF, CR, LF
USB
settings
USB ID Set the identication ID when connecting
between PC and USB.
0 to 9
TCP-IP
settings
TCP/IP
Detailed
IPAddr Auto Acq. Set the IP address automatic acquisition.
On, Off
IP Address Set the IP address.
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
* When the IP address is set automatically, the
automatically set IP address is displayed.
Sub-net mask Set the subnet mask.
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
* When the IP address is set automatically, the
automatic sub-net mask is displayed.
Port number Set the port number of the control command
server.
1024 to 65535
* This is the port number specied when
connecting our application (GL980-2000_APS).
Gateway Set the gateway.
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
* When the IP address is set automatically, the
automatic gateway address is displayed.
DNS address Set the address of the DNS server.
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
* When the IP address is set automatically, the
automatic DNS server address is displayed.
Keep Alive Set the forced disconnection time when no
communication is detected by the control
command server.
Off, 10 seconds, 30 seconds, 1 minute, 10
minutes, 30 minutes, 1 hour
Apply Settings Conrm TCP/IP settings and restart TCP/IP
processing.
FTP/WEB
server
settings
FTP Client Perform the FTP connection settings for backup
destination.
For details, refer to "FTP/WEB server setting".
FTP server port number Set the port number of the FTP server installed in
this device.
0 to 65535
WEB server port number Set the port number of the WEB server installed
in this device.
0 to 65535
Email
settings
E-mail Send
Settings
Destination
settings
To Set the destination (address) of the E-mail.
Enter the string of up to 63 characters.
CC1 to CC3 Set the destination of the E-mail (broadcast 1 to
3).
Enter the string of up to 63 characters.
Subject Set the subject of the E-mail.
Enter the string of up to 63 characters.