GRAPHTEC GL980 - Capturing; Data Replay During Capturing

3-54
CHAPTER 3 Settings and Measurement
(2) Capturing
Capture destination and le name
Elapsed time
The remaining capacity of SD card
(Remaining time more than 99999 hours is
displayed as "++++:++:++".)
The captured data is saved in the Internal RAM, internal memory, SD card or USB memory during data
capture.
You can not use the [MENU] key to change the setting.
Operations available during capture
SPAN/TRACE/POSITION change Change the settings with the [SPAN/TRACE/POSITION] key.
Screen display mode switch Change the screen mode with the [DISPLAY] key.
Replay while capturing Replay the data captured while capturing
Save to device Save to the device with the [FILE] key during data capture.
Setting check Display the setting information with the [MENU] key.
Time axis change Change the time axis with the [TIME/DIV] key.
(3) Data replay during capturing
Displays the voltage at a point
indicated by Cursor A or B or the
selected cursor.
Displays the measurement time at a
point indicated by Cursor A or B or the
selected cursor.
The captured data while capturing can be replayed by pressing the [REVIEW] key.
Use the Direction keys ( ) to move the cursor and captured data to check digital values.
Operations available during capturing
Cursor movement The [CURSOR] key is used to switch between cursors A and B.
The or
,
keys are used to move the cursors.
Save to device Recording save can be performed from the [FILE] menu.
(The data up to the present or between the cursors can be saved in a
separate le during data capture.)
Screen copy Copy the screen with the [FILE] key.
Time axis change Change the time axis with the [TIME/DIV] key.
•
During ring capturing, the replay cannot be performed while capturing.
•
During relay capturing, the data cannot be saved to a device.
•
During relay capturing, the replay cannot be performed before the le is switched while capturing.