GRAPHTEC GL980 - Span Settings; Set Waveform Color

3-63
CHAPTER 3 Settings and Measurement
Setting Description
(3) Scaling Set the scaling factor for a calculation result.
/1000000, /1000, ×1, ×1000, ×1000000
<Example>
In the case of calculation result =
0.001
In the case of calculation result =
1000
Calculation result ×1 = 0.001 Calculation result ×1 = 1000
Calculation result ×1000 = 1 Calculation result / 1000 = 1
Calculation result ×1000000 = 1000 Calculation result / 1000000 = 0.001
Span
(4) Dec pt Set the upper and lower limits of values to be converted.
* For temperature input, there is no distinction between upper and lower limits. See the
setting examples shown below for details.
(5) Upper
(6) Lower
Set the upper limit and lower limit of the span displayed in the Y-T waveform. This setting is
for calculation only.
When Operation is On, this span is used instead of the span that set in [AMP] - [Misc.] - [Span
setting].
(7) Select Select a specic engineering unit classication. (The following are available.)
Cur, Length, Area, Volume, Velocity, Accel, Freq, Mass, Energy, Pressure, Flow , Temp,
Strain, Brightness, Concentration; Optional
(8) Unit Select a unit to be used after conversion.
A unit displayed in this eld belongs to the classication selected in "Select".
To set a unit not displayed in this eld, set arbitrary text in "Arbitrary unit." The setting
selected in this eld is displayed in "Arbitrary unit". (Number of characters that can be
entered: Up to 8characters)
When EU is set to OFF, m (milli) or k (kilo), etc. of engineering unit is taken into account in the calculation.
For example, 100 mV is treated as 0.1.
When EU is set to ON, the engineering unit set in the EU character string is not taken into account. The
numerical value of the EU calculation result is the calculated numerical value.
Span settings
(1)
(2)
Setting Description
(1) Upper Set the upper limit of the span displayed in the Y-T waveform.
When EU setting is On, set the EU-converted value. (Numbers in [] are numbers before EU
conversion.)
(2) Lower Set the lower limit of the span displayed in the Y-T waveform.
When EU setting is On, set the EU-converted value. (Numbers in [] are numbers before EU
conversion.)
Set waveform color
(1)
(2)
(3)
(4)
Setting Description
(1) Current Color The currently set color is displayed.
(2) Set Color The color to set from now is displayed.
(3) Preset Color Available colors to choose from.
(4) R (red), G (green), B
(blue)
Set to 0 to 31 for each of red, green, blue (RGB)
Additional selection of colors to choose from.