GRAPHTEC GL980 - Set Active CH; Simple Setting of SPAN;POSITION;TRACE

3-35
CHAPTER 3 Settings and Measurement
Set active CH
Switch between the active CH by operating the [CH SELECT] key or the keys.
key
key
CH2 is active.CH1 is active.
Simple setting of SPAN /POSITION/TRACE
Choose each setting by pressing the [SPAN/TRACE/POSITION] key.
MONITOR SPAN POSITION TRACE
Displays digital values
(default status)
Allows changing of the
span value
Allows changing of the
position
Allows turning ON/
OFF of the waveform
display
* Data is captured even
if OFF is set.
Y-T screen
Use [CH SELECT] key or the keys to move on the CH.
Change the contents of the CH selected with the key.
* When ALL is set, setting values for CH1 is reected on other channels.
When CH1 is OFF, ALL cannot be set.
* When Logic CH is selected in "MONITOR" or "TRACE", use and keys
to select individual CH of logic.