GRAPHTEC GL980 - L-R Key Mode and Cross Key Mode

3-46
CHAPTER 3 Settings and Measurement
L-R key mode and Cross key mode
XY digital display has 2 operation modes.
2 operation modes are L-R key mode with the same key operation as the Y-T waveform screen and Cross
key mode optimized for operation of XY waveform screen.
• L-R key mode
Move XY-CH and axis with the [CH SELECT] key (hereafter CS key) or the keys.
Change the contents of XY-CH and axis selected with the keys.
While in "MONITOR" display, you can move the XY-CH with the CS key or the keys during Free
running or capturing. (This does not apply during replaying even in "MONITOR" display.)
Move XY-CH
Use the CS key or the
key to move down.
Use the CS
key or the
key to move up.
In addition to the above setting, use CS key or the keys move the axis. Then, press the same
direction key to move between XY-CH channels.
* The contents sandwiched between and marks the active XY-CH.
Move axis Move XY-CH
Use the CS key or
the
key to move
down.
Use the CS
key or
the
key to move
down.
Use the CS
key or the
key to move up.
Use the CS
key or
the
key to move up.
Change the setting contents of XY-CH/axis selected with the keys.
and keys