GRAPHTEC GL980 - Backup Setting

3-81
CHAPTER 3 Settings and Measurement
(2)-13 Backup setting
This device has a function to periodically back up recorded data.
(Refer to the gure below.)
GL980
FTP server
Ethernet
Automatic backup to an FTP server
Measurement input
Auto backup to SD memory card or USB memory
SD CARD
x GB
Lock
(1)
(2)
(3)
Setting Description
(1) Backup intervals Set the interval to back up the captured data.
Off, 1, 2, 6, 12, 24 hours ;specied time
(2) Backup Destination Set the backup destination of the captured data.
Internal memory : The data is backed up to the internal memory of the device.
SD card : The data is backed up to the SD card.
USB memory : The data is backed up to the USB memory.
FTP : Backs up data to an FTP server on the network.
* Capturing destination and backup destination cannot be the same.
* When SD card or USB memory is selected as backup destination, SD card and USB memory
can be replaced. For details, refer to "3.5 Setting Menus" - "7. File menu".
* The FTP server settings must be made using the Interface settings.
(Refer to "FTP/WEB server settings".)
(3) Save folder Set the folder to save the backup le.
* This must be a folder on the Internal memory,SD card,USB memory or an FTP server.
Example) \GRAPHTEC\¥20171001
If ring capture is On, the backup function is not available.
 WhensettotheCSVleformat,thesamplingintervalisfrom10ms.
 Toreplacethebackupdestinationmedia,besuretoexecutetheRemove/ReplaceintheFilemenubefore
replacing.
 IfthesamplingtimeisfasterbecausethenumberofeffectiveCHsislarge,orthebackupintervalislonger,
thesizeofthedatatobebackedupincreases,soitmaytaketimetonishwritingatthetimeofcapturing
stop.
WhensavingtoanFTPserver,backupmayfaildependingonthecommunicationenvironmentandtransfer
speed.