GRAPHTEC GL980 - How to Detach the Rubber Protector; How to Attach the Rubber Protector

2-5
CHAPTER 2 Checks and Preparation
2.5 How to detach the rubber protector
How to attach the rubber protector
To remove the battery pack, rst remove rubber protector.
(1) Insert one side of this device about half into the Rubber Protector.
(2) Pull the cover over the terminal block and insert the remaining half.
(3) Adjust so that the rubber protector is not out of position.
(4) Make sure that the corners and convexities are properly tted and adjust the protector so that there is no
gap.