GRAPHTEC GL980 - Span;Trace;Position

3-18
CHAPTER 3 Settings and Measurement
(2) SPAN/TRACE/POSITION
Switch to change the information on the digital display.
Use to change the settings related to waveform display during Free Running,
data capture and data replay.
Pressing the key will switch displays as follows:
MONITOR SPAN POSITION TRACE
Displays digital values
(default status)
Allows changing of the
span value
Allows changing of the
position
Allows turning ON/
OFF of the waveform
display
* Data is captured even
if OFF is set.
Y-T screen
Use [CH SELECT] key or keys to move the CH.
Change the contents of the selected CH with keys.
* When set at ALL, setting values for CH1 is reected on other channels.
When CH1 is OFF, setting for ALL is disabled.
* When Logic CH is selected, use keys to select individual CH for
Logic.
MONITOR RANGE/SPAN POSITION VERNIER
Displays the digital
value. (Default
status)
Allows changing of the
range/span value
(waveform
amplitude).
Allows changing of the
position (center
position of waveform).
Allows changing of the
vernier (ne
adjustment of
waveform amplitude).
XY screen
· L-R key mode
Use [CH SELECT] key or keys to move XY-CH and axis.
Use keys to change the contents of the selected XY-CH and axis.
· Cross key mode
Use [CH SELECT] key to move XY-CH.
Use the keys to change the contents of the X-axis, and use keys to
change the contents of the Y-axis.
(In the Quick setting area, use keys to change the contents.)