GRAPHTEC GL980 - Relay Capture Function

3-80
CHAPTER 3 Settings and Measurement
•
Relay Capture Function
< Relay capture >
(1)
(2)
(3)
(4)
Setting Description
(1) Ring/Relay capture Set the capturing function.
off: Capturing function is not used.
Ring: Ring capture is performed. (For details, refer to the gure below.)
Relay: Data is captured consecutively for each le of up to 4GB continuously.
When the ring and relay functions are enabled,available sampling interval starts from 10 ms
when the CSV le format is set.
(2) Relay mode Set the mode for performing the relay processing.
Time: After the set time has elapsed, the relay processing is performed.
Capacity: When the le has reached the set le size, relay processing is performed.
(3) Relay time Set the relay time when relay mode is set to "Time".
0 hour 1 minute to 24 hours 00 minutes
* If the le size reaches 4GB before the set time elapses, the relay processing is performed
even before the time elapses.
(4) Relay capacity Set the le size when relay mode is set to "Capacity".
10MB to 4000MB
* Estimated time for capturing with the set le size is displayed as "Relay time".
The recorded data is continuously captured by les separated in the set relay unit without losing data.
(The maximum capacity for a single le is 4GB.)