2-18
CHAPTER 2 Checks and Preparation
2.11 Connecting to a PC
Use the USB or LAN Interface to connect this device to a PC.
Connection Using a USB Cable
(1) This device complies with the EMC Directive in the state when the supplied ferrite core is attached to the
USB cable.
To connect to the PC with the USB cable, attach the supplied ferrite core to the USB cable as shown in
the following gure.
USB cable
Ferrite core (Supplied item)Lock part
(2) Connect between the device and PC with the USB cable.
USB cable
The USB connector is adjacent to the LAN connector. Make sure the cable is inserted into the correct
insert slot.
If the USB cable is used, the USB driver must be installed in your PC. Please refer to “USB Driver
Installation Manual” in the supplied CD-ROM for the appropriate installation procedure.
•
Use the cable with A and B connectors to connect this device to a PC.
A connector B connector
To Next Page
Loading...
