GRAPHTEC GL980 - Connecting to a DC Power Supply

2-8
CHAPTER 2 Checks and Preparation
Connecting to a DC Power Supply
Use the DC drive cable (B-514: option).
•
Use a power supply within 8.5 to 26.4 VDC range.
•
For DC drive cable, please be sure to use B-514 power cable.
(1) Congure the tip of the DC drive cable (B-514: 2m) to connect to the DC power supply.
(2) Connect the DC output side to the power supply connector on this device.
DC drive cable
(B-514: Option)
White (+ side) Shielded lead (- side)
(3) Connect the DC input side to the DC power supply.
Be sure to check the polarity of the wire tips when performing wiring.
(4) Press the power switch to the ON position to start.