3-122
CHAPTER 3 Settings and Measurement
(7)-4 Remove/replace SD card/USB memory
The SD card/USB memory can be not swapped during data back up.
Perform the card replacement according to the following procedure.
(1) Press the [FILE] key to open the FILE menu.
(2) Press [ENTER] key to perform “Remove/replace SD card/USB memory.
< File Menu > < Remove/replace SD card > < Remove/replace USB memory >
(3) Make sure that the message is displayed and then remove the SD card/USB memory.
When SD card is attached When USB memory is attached
SD CARD
x GB
Lock
Do not remove the SD card/USB memory until the remove/replace message is displayed.
Data may become corrupt and inaccessible.
(4) Insert the new SD card/USB memory.
When SD card is attached
When USB memory is attached
SD CARD
x GB
Lock
(5) Make sure that the device access indicator turns green and then press [ENTER] key. For access to
device access indicator, refer to “3.1 Window names and functions”.
Please perform the memory replacement within the displayed time in the message. If the displayed time
passes, data will be erased.
Each time the SD card/USB memory is replaced, the _CHG number is added to the backup le name.
Example : When backing up with backup le name " TEST".
1st SD card/USB memory: TEST_BAK2.GBD
2nd SD card/USB memory: TEST_BAK2_CHG1.GBD
To Next Page
Loading...
