GRAPHTEC GL980 - Data Replay Menu; Y-T Replay

3-130
CHAPTER 3 Settings and Measurement
(8) Data replay menu
Select the data you want to replay from the “Data replay source” by pressing the [REVIEW] key and replay
the captured data.
Press [MENU] key during replaying to display the data replaying menu.
< Y-T replay > < XY replay >
Y-T replay
Setting Description
Cursor Position Move to First Move the selection cursor to the top of the data.
Move to Last Move the selection cursor to the end of the data.
Move to Center Move the selection cursor to the middle position of the data.
Move to Trigger Move the selection cursor to the position where the trigger
occurred.
Move to Selected Selection method Set the method to specify the destination.
Position, Time
[Position] Moving
position
Specify the movement position as relative time from the
trigger point.
[Time] Moved
date/time
Specify the moving point by date and time of the data.
Call Other Cursor Move the other cursor to the position of the currently selected
cursor.
Cursor Sync Set the synchronous movement of the cursor.
Off, On
Data Search Combination Set a combination of search conditions.
Edge OR, Edge AND
Mode Set the search mode. Set it for each CH.
[Analog CH] Off, Rising, Falling, Window In, Window Out
[Logic CH] Off, H, L
* Logic CH is used for pattern comparison of all the logic CH.
[Pulse CH] Off, Rising, Falling, Window In, Window Out
[Alarm] Off, Output 1, Output 2, Output 3, Output 4
Level settings Enter the search level as a numerical value. If it is within the
range/out of range, you should set two places.
Next Search Search the next (future) position matching the search
condition from the current cursor position.
Prev. Search Search the previous (future) position matching the search
condition from the current cursor position.
Statistical Calculation Execute the statistical calculation between cursors.
Set XY Display Perform the settings for XY display.
CH Set X-axis and Y-axis of XY graph.
CH1 to CH8
Trace Set the trace of XY graph.
Off, On
Waveforms are not displayed on the screen when the trace is
set to Off. Also it is not displayed on the digital display.
Position Set the XY position.
0 to 100%
Vernier Set the XY Vernier.
40 to 100%
* The range varies depending on the range setting.