3-68
CHAPTER 3 Settings and Measurement
(1) -11 Misc.
< Pulse >
(1)
(2)
(3)
(4)
(5)
(6)
(7)
< Logic >
(1)
(3)
(5)
Setting Description
(1) Annotation Settings Set the annotation (comment) displayed in the CH.
(2) Span Settings Set the upper and lower limits of the span displayed in the Y-T waveform. (Pulse only)
* When Pulse input is Integration, it is in the auto span state and can not be set.
(3) Set waveform color Set the display color of each CH. 0 to 31 for each of red, green, blue (RGB)
(4) Line Thickness Setting Set the line thickness (1 to 8 dots). (Pulse only)
(5) Trace Set the waveform display to On or Off.
(6) Pulses per revolution 1 to 10000
When the pulse input is set to Pulses per revolution, set the number of pulses per revolution.
The number of revolutions per minute (RPM) is calculated, assuming that the number of
pulses set here is one revolution. When 100 is set, and then 100 pulses are input, it is 1
revolution when 100 pulses have been input.
<Calculation formula>
Number of revolutions (RPM) = Number of pulses ÷ Number of pulses per revolution x 60
(1 minute)
<Example>
Number of pulses per revolution: 100 (1 rotation is judged when 100 pulses have been
input.)
Pulse input: 1000 Hz (1000 pulses per sec.)
Number of revolutions: 600 RPM (600 RPM per min.)
(7) Integration clear (all CH) Clear (set to 0) the integrated value of the pulse CH that is set to the Integration input. (Pulse
only)
To Next Page
Loading...
