2-22
CHAPTER 2 Checks and Preparation
•
During data capture, when the battery power is at low, the capturing stops automatically.
•
When using in conjunction with AC adapter, this device automatically shifts to battery-powered at the time
of power outage.
At such time, pay attention to the remaining battery power. If the low-charged battery is inserted, this
device may stop abnormally due to power failure or instantaneous interruption.
•
While power is supplied directly from the DC power without the AC adapter link, and the DC voltage
reaches 16V or less, the battery charge disables.
•
When an empty battery is charged in other recorder GL220/820/900 units, the charging will stop at about
80-90%. Disconnect and re-connect the AC adapter, or remove and insert the battery pack to start charging
the battery to reach up to 100%. (depending on the remaining capacity.)
To Next Page
Loading...
