Hakko Electronics V Series - Page 198

Appendix 1 PLC2Way App1-13
When (3) is double-clicked, the [Temp. CTRL/PLC2Way Table Setting] dialog is displayed.
Set the memory addresses of the target PLC memory and target internal memory at one time
in the [Temp. CTRL/PLC2Way Table Setting] dialog.
[Use Periodical Reading]
Check this option when the following operation is required.
• Constant read from the PLC memory
• Data sampling in the PLC2 memory
[Read Cycle] (sec)
Set the cycle of reading data in the PLC2 memory.
[Store Target PLC Memory]
When storing data read from the PLC2 memory into the PLC memory, check this box and
set the desired memory address.
[Store Target Internal Memory]
When storing data read from the PLC2 memory into the V7 internal memory, check this
box and set the desired memory address.
[Temp. CTRL/PLC2Way Comm. Setting]
Clicking this button brings up the [Temp. CTRL/PLC2Way Comm. Setting] dialog and
allows you to review the setting.