App5-14 Appendix 5 Ethernet
2. Communication parameter setting
• Select [System Setting] → [Comm. Parameter]. Set the PLC to the V7 series which is
connected.
When the network table is not set:
Network table No. 0 is displayed.
It is not possible to select an option for [Connect To]. Select [System Setting] → [Network
Table Setting] → [Ethernet] →. The [Edit Network Table] window is displayed. Set the
network table, and then go back to the communication parameter setting.
For more information on network table editing, refer to page App5-16.
When the network table is set:
The IP addresses that are set on the network table are displayed.
Select the IP address of the desired PLC.
• When communicating with multiple PLCs (same model) on the Ethernet, select [1 : n] for
[Connection] on the [Detail] tab window.
Click here. A drop-down list is displayed.
To Next Page
Loading...
