42
10.1 Entering Miscellaneous Functions M and STOP ..... 356
Fundamentals ..... 356
10.2 Miscellaneous Functions for Program Run Control, Spindle and Coolant ..... 357
Overview ..... 357
10.3 Miscellaneous Functions for Coordinate Data ..... 358
Programming machine-referenced coordinates: M91/M92 ..... 358
Activating the most recently entered datum: M104 ..... 360
Moving to positions in a non-tilted coordinate system with a tilted working plane: M130 ..... 360
10.4 Miscellaneous Functions for Contouring Behavior ..... 361
Smoothing corners: M90 ..... 361
Insert rounding arc between straight lines: M112 ..... 361
Do not include points when executing non-compensated line blocks: M124 ..... 362
Machining small contour steps: M97 ..... 363
Machining open contours corners: M98 ..... 365
Feed rate factor for plunging movements: M103 ..... 366
Feed rate in millimeters per spindle revolution: M136 ..... 367
Feed rate for circular arcs: M109/M110/M111 ..... 368
Calculating the radius-compensated path in advance (LOOK AHEAD): M120 ..... 369
Superimposing handwheel positioning during program run: M118 ..... 371
Retraction from the contour in the tool-axis direction: M140 ..... 372
Suppressing touch probe monitoring: M141 ..... 373
Delete modal program information: M142 ..... 374
Delete basic rotation: M143 ..... 374
Automatically retract tool from the contour at an NC stop: M148 ..... 375
Suppress limit switch message: M150 ..... 376
10.5 Miscellaneous Functions for Laser Cutting Machines ..... 377
Principle ..... 377
Output the programmed voltage directly: M200 ..... 377
Output voltage as a function of distance: M201 ..... 377
Output voltage as a function of speed: M202 ..... 378
Output voltage as a function of time (time-dependent ramp): M203 ..... 378
Output voltage as a function of time (time-dependent pulse): M204 ..... 378
10 Programming: Miscellaneous Functions ..... 355
To Next Page
Loading...
Need help?
General
