Documentation HERMA 500
1.10 GB (2019/02/28)
95
Cleaning, maintenance, service
Cleaning, Maintenance, Service
Authorised Staff
User 1 – for general cleaning tasks
Specialist – for replacing components
Switch off the applicator!
Accessing the machine for cleaning and maintenance purposes could cause unexpected actions and
short circuits. For this reason, observe the following:
Switch off the power supply before maintaining or cleaning the machine.
Reattach any protective covers after this work is complete.
The machine may only be operated, maintained and serviced by trained personnel. Additional training must be
provided.
When the machine is switched off for maintenance and servicing, ensure that the main switch cannot be switched
back on without authorisation.
After you disconnect the HERMA 500 applicator from the mains, wait at least five minutes before opening the
housing or touching the connection pins.
RESIDUAL VOLTAGES!
Failure to observe this information could result in serious injuries.
Deactivate the compressed air!
Disconnect the compressed air supply before cleaning the machine or performing maintenance work.
To Next Page
Loading...
