Herma 500 - Storage; Start-Up after Storage; Disposal

Documentation HERMA 500
1.10 GB (2019/02/28) 55
 Connect the applicator to the compressed air supply.
 If applicable, activate the pneumatic system of the machine by setting the valve accordingly.
Representative photo
Storage
Observe the following to ensure that applicators that will not be in use for a longer period of time will still function
properly:

The storage location must be dry and clean.
 Do not expose the applicator to extreme cold or heat.
 Make sure the applicator is positioned on an even surface to prevent warping or twisting.
 Clean the applicator.
 Cover the applicator completely to prevent dirt or dust from getting into it.
Start-up After Storage
Perform the following activities when starting up the applicator after it has been stored for a long period of time:

Check all safety and protective equipment and replace any damaged components.
 Clean and inspect the applicator according to the maintenance schedule.
Disposal
 Observe local regulations regarding waste prevention and proper recycling and/or disposal.