Documentation HERMA 500
1.10 GB (2019/02/28) 83
Note: If you cannot establish a connection, delete your browser’s cache.
If necessary, you can assign your own unique IP address and a unique port.
As a rule, in order to open a web front end, the display device (PC, laptop, industrial controller, etc.) only needs to
be in the same IP address range. With the standard IP address, for example, that would be 192.168.3.XXX
(where XXX is a number between 0 and 255).
The Ethernet cable to be used must have an RJ45 plug on the applicator side.
OPC UA Settings
Various settings for the Ethernet connection (OPC UA).
User/Password
This menu lets you define the PINs/passwords for the users, the technician and the customer’s service technician
(password level 3 or 4 required).
Fieldbus Settings
Various settings for the fieldbus connection (industrial Ethernet).
Other Settings
Various special settings.
Alarm History
Password level 4 and higher. A list of the approx. 100 most recent messages on the applicator.
Imprint
This menu lets you access device-specific information, e.g. the device ID, software versions, etc.
Further information about the manufacturer of the HERMA 500 can be found in the “Applicability” section.
To Next Page
Loading...
