Direct Parameter Access
72 1.10 GB (2019/02/28)
Direct Parameter Access
You can access the parameters for the control program by browsing through the individual menus.
If you already know the number of the parameter, you can access it quickly by pressing the direct selection button
on the start screen and entering the number.
Please note that you need the necessary authorisation to open the selected parameter.
Operation Mode On/Off
Tap this button to switch the applicator’s operation mode on or off. Different start screens are displayed
depending on the applicator’s status. See also “Operation Using the Control Program”.
Operation mode must be switched on for production to take place. Operation mode must also be on for you to
access the favourites and view or change their values.
Message History
You can open a list of past messages on the display using icon 12. This provides an overview of all events,
including those that occurred while you were away.
To Next Page
Loading...