Herma 500 - Format List

Documentation HERMA 500
1.10 GB (2019/02/28) 79
This menu provides a list of the available formats, which you can select and load to the primary memory by
tapping on them. You can also save new formats (the currently configured values) in new or existing storage
locations. If you also want to change the name, you have to operate the applicator from an external system with a
keyboard. You can do so by establishing an Ethernet connection from an external terminal, for example a PC.
See also the instructions on Ethernet connections in the Extended settings menu.
Format List
This list lets you load or delete a previously saved format. Tap a name and then tap one of the following buttons.
Load the format to the primary memory, thus activating it.
Delete the format. A security prompt asks you to confirm your choice.
Save Format
Save the currently configured values in the currently selected format.
Save Format As
Save the currently configured values in a different storage location. An external Ethernet connection allows you to
change the format name.
Settings
General, mostly one-time settings for the control program, e.g. the display language or the display alignment.
NOTICE: You can see an explanation for a parameter by tapping on the parameter text and then on the icon on
the display.
For parameters that require additional explanation, these explanations can be found in the corresponding sections
of the manual.
Product
Make product-specific settings, e.g. start delay, master encoder, etc.
NOTICE: You can see an explanation for a parameter by tapping on the parameter text and then on the icon on
the display.
For parameters that require additional explanation, these explanations can be found in the corresponding sections
of the manual.